75t & 35t Firmware Flashing (2nd PC)
Everything is on your second pc other than DriverE download
Get your DNA ID first and make a ticket on your discord and your firmware will be provided and driver if you have purchased from us.
First, make sure the 75t & 35t Flasher is installed on your system.
Download the 75t & 35t flashing tool with the file above.
Extract and Swtich to Jtag port (The port closest to the motherboard is the JTAG port, while the one farthest from it is the DATA port.)
75t Flashing
After extracting open the file and open CH347 JTAG Drivers>CH341PAR>SETUP Once you run set up, click Install.
Open the file called Flashing Tools Make sure you delete the file named "pcileech_squirrel_top.bin". Then paste your provided firmware file into the folder.
Then Run the "CH347 75T Flasher" Wait until it says "success".
After close the file and download the "DriverE" File provided on your main pc.
Once the process completes and you see a success message, run a Speed test to confirm everything is working correctly.
If not please cold boot your pc.
35t Flashing
After extracting open the file and open CH347 JTAG Drivers>CH341PAR>SETUP Once you run the set up, click Install.
After open RS232 JTAG Drivers>zadig-2.5 Once you run the set up, click "Install WCID Driver" and wait
Open the file called Flashing Tools Make sure you delete the file named "pcileech_squirrel_top.bin". Then paste your provided firmware file into the folder.
Then Run the "RS232 35T Flasher" Wait until it says "success"
After close the file and download the "DriverE" File provided on your main pc.
Once the process completes and you see a success message, run a Speed test to confirm everything is working correctly.
If not please cold boot your pc.
If there are any issues, please see the DMA Troubleshooting section before messaging support
Last updated